The THYRITOP 400 can be completed with the following accessories (options):
- THYRITOP TOOL PRO software
Configuration of the Thyritop 400 via a USB/µUSB cable, display of the current, voltage, power and inputs/outputs. Control of the Thyritop 400 and display of the curve with storage of the data.
- LBA3 Graphical Interface
Simplifies the configuration of the Thyritop 400 with the "Easy Start" menu, can display up to 6 quantities simultaneously, equipped with a memory for storing the configuration and cloning it onto another Thyritop 400, Datalogger function.
- dASM synchronization module
This module allows smoothing of the network power and optimization of energy consumption when several Thyritop 400 controllers are used on the same network. This anti-flicker system considerably reduces current peaks.
- Input/output boards
External measurements board: can be used to control the power or limit the current on the basis of measurements from outside the Thyritop 400 (e.g. voltage and current measurement on the transformer secondary when the Thyritop 400 is positioned on the primary). This allows power control and cutoff as close as possible to the load.
Digital input/output boards: these increase the input/output capacity of the Thyritop 400 by adding 9 digital inputs and 3 logical outputs. The action of these inputs/outputs is defined using the THYRITOP TOOL PRO software (e.g. change from the power control mode to status change of an input).
Digital and analogue input/output board: this increases the input/output capacity of the Thyritop 400 by adding 4 digital inputs, 3 logical outputs and 3 analogue outputs. The action of these inputs/outputs is defined using the THYRITOP TOOL PRO software.
- Communication module: the Thyritop 400 is particularly open to the following networks
- Profibus/Profinet
- Modbus RTU/Modbus TCP
- Devicenet/Ethernet I/P
- ETHERCAT